Granted, I would fill a gallon hug and let it sit on the counter for a day to allow the chlorine to dissipate. I'm the town I reside in, they use the RO process to treat the water and I have absolutely no concerns with using and do use my tap water as a dilution for antifreeze. This is a very expensive way to treat water, however the end result is a high quality product.Įither process used by a municipality is then treated with chlorine and fluoride. Water is forced through a membrane that strips the water of the impurities. I'm a modern water treatment facility, water is treated through a reverse osmosis process. Then other chemicals are added to treat the lime. The main softening agent is lime, not salt. There are basically two methods for cleaning the water before it reaches the end consumer.Īn older method and is slowly being replaced, is a lime softening process. Now to move onto municipal water systems. Sure there may be trace amounts of salt in your tap water, but not one I would be concerned with. A properly sized, and programmed water softener way only cycle through its self cleaning process 1- 2 times per week. This cleaning of the resin is not a daily process, or at least it shouldn't be. During the cleaning process of the resin, the brine solution is rinsed from the unit. The salt that is added into the tank of your softening system is diluted into a brine, in which is used to clean the resin within the softener. A residential water softener uses a resin to condition (clean) the Iron and minerals from the water, not salt. However these amounts would be minute amounts. There MAY be a residual salt content in water that has been conditioned by a residential water softening system. JTX, you are partially correct with your statement about salt in the water. Soft water has all elements of iron and minerals removed. Hard water is water that has any iron or minerals higher than zero mg/l. I wasn't going to chime on on this, but I am seeing some erroneous information here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |